Factory Direct ADSS Anchor Clamp - Premium Quality for Secure Cable Installation

The ACADSS clamps are designed for dead-ending aerial ADSS cables on access networks where spans do not exceed 90 m. All parts are secured together to prevent any loss during installation. Different capacities are available to adapt to the cable diameter. They consist of a conical body and wedges which hold the cables under tension while preserving the fibre properties. Two models are available depending on the cable structure: 1- Compact series with 165 mm wedges for light ADSS cables up to 14 mm dia. 2- Standard series with 230 mm wedges for high fibre count ADSS cables up to 19 mm dia. Compact Series

Part #	Designation	Cable 0	Weight	Pack’g
09110	ACADSS 6	6 - 8 mm
1243	ACADSS 8	8 - 10 mm	0.18 Kg	50
09419	ACADSS 12C	10 - 14 mm

Standard Series

Part #	Designation	Cable 0	Weight	Pack’g
0318	ACADSS 10	8 - 12 mm
0319	ACADSS 12	10 - 14 mm
1244	ACADSS 14	12 - 16 mm	0.40 Kg	30
0321	ACADSS 16	14 - 18 mm
0322	ACADSS 18	16 - 19 mm

Double dead-end for tangent support at angle route using (1) ACADSS clamps, (2) BracketThese clamps are used as cable dead-end at end poles for terminating the cable route (using one clamp).

Single dead-end using (1) ACADSS clamp, (2) Bracket Two clamps can be installed as double dead-end in the following cases: ● At jointing poles ● At intermediate angle poles when the cable route deviates by more than 20° ● At intermediate poles when the two spans are different in length ● At intermediate poles on hilly landscapes

Double dead-end using (1) ACADSS clamps, (2) Bracket

Attach the clamp to the pole bracket using its flexible bail.

Place the clamp body over the cable with the wedges in their back position.

When the cable is brought to its installation load at the end pole, the wedges move further into the clamp body. When installing a double dead-end leave some extra length of cable between the two clamps.